Product Link Infiniti G37: Multicolor Built Headlights (2010-2013)
Important Note:
For some vehicles, the DRL harness must be installed for the headlights to function correctly.
Caution: Avoid using dielectric or any type of weather-sealing grease on connectors or sockets. Doing so may cause connection issues and void the warranty.
PART I REMOVE HEADLIGHTS
PART II INSTALL HEADLIGHTS
PART I REMOVE HEADLIGHTS
Disconnecting the Negative Battery Terminal
Before working on your vehicle, always begin by disconnecting the negative battery terminal. This step helps prevent accidental electrical shorts and ensures your safety while handling electrical components.
Remove the Bumper
Use a panel popper to remove the seven plastic push pins that secure the center grille to the front bumper.
Lift the cover to access and remove the 10mm bolts securing the mounting bracket
Repeat the same steps on the other side of the bumper to remove the mounting bracket.
Remove the push-in pin from the wheel well, then open the liner cover to access and remove the 10mm bolt securing the inner side of the front bumper
Gently pull the edge of the front bumper outward to detach it from the mounting. Repeat the same steps on the other side of the upper front bumper.
Carefully remove the entire front bumper by pulling it outward. Be sure to disconnect the fog light connectors before fully removing the bumper.
Remove the Headlights
To remove the headlight, unscrew the four 10mm bolts: two on the top, one on the side, and one at the bottom of the assembly.
To remove the headlight, unscrew the four 10mm bolts: two on the top, one on the side, and one at the bottom of the assembly.