Step 1: Test your Product. This ensures no manufacturing defects are in the LEDS, and that you understand how to wire your product properly. See the wiring guide that comes with your product or (visit our Wiring Guide)
Step 2: Remove your bumper to access headlights. (The process of accessing the headlight may differ depending on the vehicle. This step may or may not be necessary for your specific vehicle. For tailored instructions, you can consult our help center or search the web for vehicle-specific guidance on how to proceed.)
Step 3: Open your headlights. (*Headlights can be safely opened and resealed using the process outlined in the video below)
Step 4: Install your LED Product into your headlights.
Halo Kits | Halo Rings | Info – RGB HALO KITS
There are a few ways to mount your halo ring or halo kit.
1. Use the 3M adhesive tape
- 3m tape can found on the backside of your halo ring (available on most kits). Simply peel off the film covering, aim and mount!
- For extra security, be sure to use adhesive promoter or sand the surface you’ll be applying the halos to before mounting.
2. Epoxy
- Simply spread epoxy along the backside of the halo and stick onto its desired location.
- Hold until secure or dry.
3. Use the beading wire method
Halo Mounting Wire – RGB Halo Kits
- Beading or craft wire can be tied around the halo and used to secure the halo down.
- This usually requires drilling a small hole on each side of the headlight internals where the halo will mount.
- Run the wire through the hole and twist lock the open ends together on the backside of the headlight until firm.
Additional Mounting Tips:
- In some applications, you may need to drill a small hole to run wiring through before mounting your halo ring.
Step 5: Reseal your headlights (see video above) or click here for full guide.
Step 6: If you haven't already, wire your LED Product onto your car using the included wiring guide or see our general wiring guide here.