How to Mount Halo Rings / Headlight Halos

There are a few ways to mount your halo ring or halo kit 


1. Use the 3M adhesive tape

  • 3m tape can found on the backside of your halo ring (available on most kits). Simply peel off the film covering, aim and mount!
  • For extra security, be sure to use adhesive promoter or sand the surface you’ll be applying the halos to before mounting. 



 2. Epoxy

  • Simply spread epoxy along the backside of the halo and stick onto it’s desired location.
  • Hold until secure or dry. 


3. Use the beading wire method

Halo Mounting Wire – RGB Halo Kits

  • Beading or craft wire can be tied around the halo and used to secure the halo down. 
  • This usually requires drilling a small hole on each side of the headlight internals where the halo will mount.
  • Run the wire through the hole and twist lock the open ends together on the backside of the headlight until firm.



Additional Mounting Tips:

  • In some applications, you may need to drill a small hole to run wiring through before mounting your halo ring 
Was this article helpful?
0 out of 0 found this helpful