Yes. Our lighting products use waterproof M8 or M6 connectors and are designed for rain, storms, and normal car washing. Heavy pressure washing directly against headlight seals is not recommended.
Yes. Our headlights, LED emblems, controllers, and lighting components are built to withstand normal car washing, rain, and storms.
We have upgraded our kits across all product lines to use waterproof M8 or M6 connectors, depending on the product. These connectors help protect the wiring connections from water exposure during normal use.
LED Emblems
Our LED emblems are fully waterproof inside and out. They are designed to handle rain, storms, and normal car washing without issue.
Controllers and Wiring Components
Our controllers and components use waterproof M8 or M6 style connectors on most current kits. These are designed to withstand normal exterior use, including rain and car washing.
Custom Headlights
Our custom headlights are thoroughly sealed to withstand normal car washing and rain.
However, heavy pressure washing directly against the headlight seal is not recommended. In some cases, extreme pressure can force water past the seal or into areas that would not normally be exposed during regular washing or driving in rain.
Best Practice
For the best long-term results, avoid holding a pressure washer directly against:
- Headlight lens seams
- Rear headlight caps
- Wiring entry points
- Controller connections
- Emblem wiring exits
Normal washing, rain, and storms are fine. Direct high-pressure spraying at close range should be avoided.
Comments
0 comments
Article is closed for comments.