Note for RGBW Version: No LED driver is needed – just connect to power.
1. Test the Lights
- Before installing, connect the LED product to power to make sure it works properly.
2. Clean the Surface
- Use an alcohol-based cleaner to wipe the area where the LEDs will stick. Let it dry.
3. Position the LEDs
- Hold the LED product in place to check alignment.
4. Peel and Stick
- Peel off the adhesive backing, stick the LEDs onto the cleaned surface, and press firmly.
5. Connect to Power
- Attach the LEDs to your car's power source and double-check everything works
Refer to our Wiring Guides All LED Types: (RGBW | RGBWA | Flow Series) – RGB HALO KITS