Dodge Ram Illuminated Emblem install guide


Product link:

Installation Guide 1.0:


This Product has been updated to 2.0 Version 

The wires now go out the back of the emblem allowing them to be fully invisible after installation. 

To get the best results we recommend

1.  The wires from the emblem are partially covered by 3m tape on back, (please cut around this to allow the wires to come straight out the back of each letter)

2. Once factory letters are removed, drill a large enough hole in the grille for the wires to go through straight out back (hole will be covered up by the emblem itself) 

3. Product can be installed with or without removing the bumper 


ram install  (1).png


Was this article helpful?
0 out of 0 found this helpful