300 LED Emblem Badge: (Multicolor) Install Guide

Product Link:

300 LED Emblem Badge: (Multicolor) 


Install Guide:

  1. Test Kit Before Installation: Before proceeding with installation, it's crucial to test the kit to ensure all components are functioning correctly. Connect the wires to the controller and verify that the LED lights illuminate properly. See our Wiring Guide (Flow Series, Color Chasing) – RGB HALO KITS.

    For easier access and a cleaner installation, we recommend removing the grille of your Chrysler 300. This will provide better visibility and maneuverability during the installation process.
  2. Remove Rear Bracket: Unscrew the rear bracket from the LED emblem to access the back of the emblem for installation.
  3. Position Emblem and Route Wires: Carefully place the LED emblem onto the grille of your Chrysler 300 in your desired position. Simultaneously, run the wires from the LED emblem through the grille and into the controller. Make sure it is centered and aligned correctly for the best aesthetic appeal while ensuring neat wire routing to avoid tangling or interference.
  4. Secure with Bracket Plate: Once the emblem is positioned correctly, screw the back bracket plate onto the emblem. Ensure that the screws are tightened securely to hold the emblem in place.
  5. Finalize Installation: Double-check all connections and ensure that the emblem is securely attached to the grille. Test the LED lights to make sure they are functioning properly.
  6. Enjoy Your New Look: With the installation complete, step back and admire the enhanced appearance of your Chrysler 300 with the stylish LED emblem. Get ready to turn heads wherever you go!


Was this article helpful?
0 out of 0 found this helpful